Scan View SCANMATE F10 Manuel d'instructions télécharger pdf (Page 20)

two different dimensions) are supplied with the scanner. By placing the pins

in the holes along the front of the scanner tray as shown in the diagram below,

you can quickly adapt the scanner to any of the above mentioned systems.

Calibration

Because the output of the scanner’s light source changes slightly over time,

white point calibration is necessary to ensure consistent scanning results.

White point calibration should be carried out when the scanner is first

installed and each morning before starting work.

Geometric calibration and focus calibration are rarely necessary, but

should be done at the time of installation and can be repeated later if

necessary.

For instructions on all three types of calibration, please see “Scanner

Calibration and Focus Adjustment.”

General operating procedures

3•2

ScanMate F10 • Operator’s Manual

Large pin for Bacher Control 2000

and Stoesser systems.

Top ø 6.35 mm

Bottom ø 3 mm

Small pin for Montaloch and

Beil systems.

Top ø 5 mm

Bottom ø 2.5 mm

S1 S1S2 S2S1

Ba Ba

Ba = Bacher Control 2000 (2 x 196.5 mm)

S1 = Stoesser (2 x 216 mm)

S2 = Stoesser (2 x 108 mm)

M = Montaloch (2 x 195 mm)

Be = Beil (2 x 200 mm)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Pas de commentaire

Scan View SCANMATE F10 Manuel d'instructions Page 20